Bomba sumergible marca Myers MW50-11P

The Myers MW50 series sewage pumps are constructed of the most durable combination of materials to withstand the harshest sewage environments. The non-clog impeller can pass up to 2” solids. Provides the flow and head required residential and light commercial applications. Models available for manual operation with external controls, or automatic operation with tethered, piggyback mechanical float switch. APLICACIONES Sewage, high-capacity sump, effluent ESPECIFICACIONES Capacities – 135 GPM (510 LPM) Shut-off Head – 27’ (8.23 m) Operation – Manual or automatic Solids Handling – 2” (50.8 mm) Liquids Handling – Domestic sewage and drain water Intermittent Liquid Temperature – Up to 140°F (60°C) Motor/Electrical Data – 1/2 HP, 1625 RPM, PSC (1Ø), oil-filled, 115V, 9A, 1Ø, 60Hz; 230V, 4.5A, 1Ø, 60Hz Acceptable pH Range – 5-9 Discharge, NPT – 2” (50.8 mm) Housing – Cast iron Power Cord – 20’, 16/3, SJTW Impeller – Thermoplastic Volute Case – Class 30 cast iron Shaft Seal – Type 6, carbon and ceramic Minimum Sump Diameter – Simplex: 24” (61 cm); Duplex: 36” (91.4 cm) CARACTERÍSTICAS Two-vane Impeller provides maximum efficiency and eliminates jamming between impeller and volute – engineered thermoplastic composition. Restore Performance Original performance standards can be restored by easily replacing a worn volute seal ring. High-capacity Handling: Passes full 2” solids. Cool Running, durable, oil-filled motor for continuous bearing lubrication and maximum heat dissipation. Powerful Starts High-torque, permanent split capacitor (PSC) motor; no starting switches or relays to wear out. Protects Against High Heat low amp draw from the efficient PSC motor means less heat build-up. Longer-lasting Motor lower ball bearing eliminates sleeve bearing wear and reduces motor wear. Improved Sealing: Long, flexible Type 6 seal provides high-pressure sealing with improved seal face protection by location.